Remove the high strength double-sided adhesive from the back of the plate. In the case of a relatively low temperature, heat installation location, and plate with a hair dryer or a heat gun on low setting. Carefully place the product in desired location and press down for about 1-2 minutes, Note: do not wash your car for 24-hours. The adhesive should be cured after 12-hours.International Buyers - Please Note. We understand that sometimes an item may not turn out to be just what you need. DO NOT send without communication. We open Monday to Saturday. We answer every message within 24 hour period. Our customer service representative is here to ensure that you are satisfied with our services. So yourPOSITIVE FEEDBACK is very important. And welcome back to our store again. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Exterior Parts & Accessories\Body Moldings & Trims". The seller is "elva-trim" and is located in this country: CN. This item can be shipped worldwide.